PDF (1527K)
摘要
在连续流动固定床加氢装置上,采用NiW-P/Al2O3催化剂对高温煤焦油脱除大部分S、N、O后经蒸馏切割得到的芳烃质量分数较高的柴油馏分进行加氢精制,考察了反应温度、反应压力、液体体积空速和氢油体积比对芳烃脱除率和产物分布的影响,得到的最佳工艺条件为:反应温度为340℃,反应压力为8.0 MPa,液体体积空速为0.3 h-1,氢油体积比为1 500。结果表明,适宜的反应温度和氢油体积比、较高的反应压力和较低的液体体积空速有利于柴油馏分中芳烃的脱除,其脱除率达到70%以上。
Abstract
In a continuous flow fixed bed reactor,the diesel distillate with high aromatics content,which is obtained by removing most of S,N and O and then cutting distillation of coal tar,is refined through hydrogenation under the presence of NiW-P/Al2O3 catalyst.The effects of temperature,pressure,liquid volume space velocity (LHSV) and volume ratio of hydrogen to oil on the removal rate of aromatics and product distribution are investigated.The optimum conditions are determined as follows:reaction temperature at 340℃,reaction pressure at 8.0 MPa,LHSV at 0.3 h-1 and volume ratio of hydrogen to oil at 1 500.The results indicate that suitable temperature and volume ratio of hydrogen to oil,higher reaction pressure and lower LHSV are helpful to remove aromatics.The removal rate can exceed 70%.
关键词
煤焦油
/
芳烃
/
加氢
/
烷烃
/
工艺条件
Key words
coal tar
/
aromatics
/
hydrogenation
/
alkane
/
process conditions
Author summay
宋毛宁(1992-),男,硕士研究生,研究方向为煤化工,smn969178034@163.com;崔海涛(1977-),男,博士,助理研究员,研究方向为工业催化,cuiht@sxicc.ac.cn。
煤焦油加氢脱芳工艺条件的优化[J].
现代化工, 2017, 37(7): 100-104 DOI:10.16606/j.cnki.issn0253-4320.2017.07.023