Please wait a minute...
 
最新公告: 重要提醒:骗子冒充编辑部要求加作者微信,谨防上当!   关于暑假、寒假期间版面费发票及期刊样刊延迟邮寄的通知    
现代化工  2017, Vol. 37 Issue (10): 93-96    DOI: 10.16606/j.cnki.issn0253-4320.2017.10.022
  科研与开发 本期目录 | 过刊浏览 | 高级检索 |
油田污泥离心脱水减量处理现场试验
王兴旺, 魏立新, 刘鹏, 李凯欣, 成毅, 张煜
东北石油大学提高油气采收率教育部重点实验室, 黑龙江 大庆 163318
Site test for centrifugal dehydration reduction treatment of oilfield sludge
WANG Xing-wang, WEI Li-xin, LIU Peng, LI Kai-xin, CHENG Yi, ZHANG Yu
Key Laboratory for Enhanced Oil & Gas Recovery of the Ministry of Education, Northeast Petroleum University, Daqing 163318, China
下载:  PDF (1284KB) 
输出:  BibTeX | EndNote (RIS)      
摘要 为了保证注水水质达标,油田污水站采用连续排泥工艺降低悬浮物和泥沙的含量,由此产生大量含水率高的污泥,造成运输费用及后续无害化处理费用的增加,因此,需要对污泥进行减量处理。以卧螺离心机为关键设备,设计了1套污泥离心脱水减量工艺。通过现场试验得到转速、差速、絮凝剂投加量、温度对减量效果的作用规律。在一定范围内,转速越高、差速越低、絮凝剂投加量越大、温度越高,处理后的污泥含水越少。采用正交试验方法优化得到工艺最佳运行参数:转速为2 500 r/min,差速为9 r/min,加药量为225 g/m3,温度为55℃。处理后,平均含水率从入口的97.37%下降到出泥口的59.17%,平均含固率从入口的1.73%上升到出泥口的33.72%。离心机出水口和出泥口分流比范围为24.14∶1~33.19∶1,对应的污泥减量比例为96.02%~97.08%,污泥减量效果很好。
服务
把本文推荐给朋友
加入引用管理器
E-mail Alert
RSS
作者相关文章
王兴旺
魏立新
刘鹏
李凯欣
成毅
张煜
关键词:  油田污泥  卧螺离心机  减量处理  方案优化  分流比    
Abstract: In order to ensure the quality of added water to meet the standards,the oilfield sewage station uses continuous sludge discharge process to reduce the content of suspended solids and sediment in water,which brings about a large amount of sludge with high water content,and increases the cost in transport and subsequent harmless treatment.Therefore,it is necessary to reduce the generated amount of sludge.A centrifugal dehydration reduction process for sludge is designed using decanter centrifuge as the key equipment.The influence rules of the rotational speed,differential speed,flocculant dosage and temperature on the reduction effect are obtained through site test.In a certain range,the higher rotational speed,the lower differential speed,the larger flocculant dosage,and the higher temperature all benefit the reduction of water content in treated sludge.The optimum operating parameters obtained by orthogonal test method are as follows:rotational speed is 2 500 r·min-1,differential speed is 9 r·min-1,flocculant dosage is 225 g·m-3 and temperature at 55℃.After treatment,the average water content in sludge decreases from 97.37% at the inlet to 59.17% at the sludge-outlet,and the average solid content increases from 1.73% at the inlet to 33.72% at the sludge-outlet.The split ratio of the water-outlet to sludge-outlet of the decanter centrifuge is 24.14:1-33.19:1,the corresponding sludge reduction ratio is 96.02%-97.08%,representing a good sludge reduction effect.
Key words:  oilfield sludge    decanter centrifuge    reduction treatment    scheme optimization    split ratio
收稿日期:  2017-06-12                出版日期:  2017-10-20
TE992  
基金资助: 国家自然科学基金资助(51674086)
通讯作者:  王兴旺(1990-),男,博士研究生,研究方向为油田污水处理技术,通讯联系人,deshengp1600@163.com    E-mail:  deshengp1600@163.com
作者简介:  魏立新(1973-),男,博士,教授,博士生导师,主要研究方向为油气储运工程优化与节能降耗技术,wlxfyx@sina.com。
引用本文:    
王兴旺, 魏立新, 刘鹏, 李凯欣, 成毅, 张煜. 油田污泥离心脱水减量处理现场试验[J]. 现代化工, 2017, 37(10): 93-96.
WANG Xing-wang, WEI Li-xin, LIU Peng, LI Kai-xin, CHENG Yi, ZHANG Yu. Site test for centrifugal dehydration reduction treatment of oilfield sludge. Modern Chemical Industry, 2017, 37(10): 93-96.
链接本文:  
http://www.xdhg.com.cn/CN/10.16606/j.cnki.issn0253-4320.2017.10.022  或          http://www.xdhg.com.cn/CN/Y2017/V37/I10/93
[1] 陈忠喜.大庆油田含油污水及含油污泥生化/物化处理技术研究[D].哈尔滨:哈尔滨工业大学,2006.
[2] 薛涛.含油污泥无害化处理与资源回用技术研究[D].西安:长安大学,2003.
[3] 杨双春,刘国斌,张金辉,等.国内外含油污泥处理技术研究进展[J].现代化工,2012,(11):36-39,41.
[4] 梅洛洛,王炳人,徐周云,等.含油污泥多元无害化处理试验研究[J].现代化工,2015,(11):103-105,107.
[5] 李庄,李金林,赵凤伟.含油污泥焚烧技术及其在海外油田项目的应用[J].中国给水排水,2015,(16):76-79.
[6] 刘利群,刘春江.间接热解吸技术在含油污泥处理中的应用[J].天然气与石油,2017,(2):117-120.
[7] 谭蔚,邢帅,贡皓霜,等.热碱水洗-机械脱水工艺处理石油污染土壤[J].现代化工,2016,(6):63-66.
[8] 高雯,董良飞,张凤娥,等.不同调理剂对含油污泥脱水性能的影响研究[J].中国给水排水,2016,(19):115-119.
[9] 董秀梅.含油污泥脱水减量技术研究[D].青岛:中国石油大学,2010.
[10] 张珂,朱建华,周勇,等.测定样品中油和/或水含量的装置及方法:中国,CN102778409A[P].2012-11-14.
[1] 钱翌, 周绍杰, 李姗姗, 武洋. 阻燃EVA/油田污泥/石墨复合材料的性能研究[J]. 现代化工, 2017, 37(2): 107-111.
[2] 魏立新, 李哲, 王倩楠, 王佳楠, 杨贺. 离心式污泥减量化处理工艺方案优化[J]. 现代化工, 2016, 36(6): 136-140.
[1] . [J]. Modern Chemical Industry, 2015, 35(11): 77 -80 .
[2] . [J]. Modern Chemical Industry, 2015, 35(12): 128 -130,132 .
[3] . [J]. Modern Chemical Industry, 2017, 37(6): 103 -0106,108 .
[4] . [J]. , 2003, 23(5): 0 .
[5] . [J]. , 2009, 29(6): 0 .
[6] . [J]. , 2010, 30(3): 0 .
[7] . [J]. , 2010, 30(7): 0 .
[8] . [J]. , 2007, 27(2): 0 .
[9] . [J]. Modern Chemical Industry, 2014, 34(2): 131 -133 .
[10] . [J]. Modern Chemical Industry, 2014, 34(4): 14 -16 .
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
京ICP备09035943号-37
版权所有 © 《现代化工》编辑部
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn